Preorder: The item has been back-ordered from the manufacturer and will arrive shortly. (approx. CW 39 / 22.09.2025 - 28.09.2025)
The item will be dispatched as soon as possible as soon as it reaches our warehouse.
Use the xTool MetalFab air dryer in combination with the xTool air compressor and eliminate the need for costly gas cylinders. Achieve burr-free cuts of 4 mm stainless steel, 4 mm aluminum, or 3 mm brass with just 6 bar of air pressure. All you need is the air compressor, the air dryer, and the xTool SaveGas™ nozzle.
The xTool air dryer uses a three-stage industrial filtration system that removes 99% of moisture, impurities, and oils to ensure ultra-clean, dry air for maximum cutting quality.
Note: The xTool MetalFab air dryer can only be used in combination with the air compressor.
- Size: 40.2 cm × 35.5 cm × 22.7 cm
- Weight: 10.8 kg
- Filtration efficiency: 99% moisture removal, 99.999% oil/rust removal
- Max. airflow: 400 L/min
- Maximum air pressure: 12.5 bar (1.25 MPa)
- Dew point: 2 °C to 10 °C
- Air inlet temperature: ≤45 °C
- Rated power: 380 W (0.51 HP)
- Operating voltage:
- EU/UK: 220 V, 2.6 A
- US: 110 V, 4.8 A
- Pipe diameter: 10 mm
- Operating temperature: -10 °C to 40 °C
- Air dryer
- 2 filters
- Wrench
- Screwdriver
- Hose (3 m)
- Safety instructions
- User manual
The Makeblock success story began in 2012 when Jasen Wang, the founder and CEO, had a groundbreaking idea. As a passionate maker, Jasen realised how difficult it can be to turn a creative idea into reality. This drive gave rise to his first project: Makeblock.
Makeblock specialises in promoting STEAM education. The company helps young students develop their creativity by developing educational infrastructure - including robotics modules, coding software and laser cutters. The aim is to give pupils the tools to learn technical knowledge and creative skills through play.
At the end of 2020, Makeblock expanded its portfolio and entered the field of laser machines. With the xTool project, the product range was expanded so that not only students but also adults can benefit from the solutions. Creativity is not just about developing programming robots - it is also about personalising everyday objects, such as engraving names on mugs or creating works of art from wood.
With the launch of the first product, the xTool D1 in 2021, Jasen started a new chapter in his vision. While the Makeblock success story continues, xTool marks the start of an exciting new episode.
Contact:
MAKEBLOCK (HONG KONG) COMPANY LIMITED
19H Maxgrand plaza No.3 Tai Yau Street
San Po Kong, Kowloon, Hong Kong
European subsidiary
Makeblock Europe BV
Oostergracht 48, 3763 LZ Soest, Niederlande
Phone: +31 6 1264 5740
EMail: eu@makeblock.com
Register entries:
Registered with the Dutch Chamber of Commerce (KvK): 68916752
VAT no.: NL857646655B01
