Preorder: The item has been back-ordered from the manufacturer and will arrive shortly. (approx. CW 39 / 22.09.2025 - 28.09.2025)
The item will be dispatched as soon as possible as soon as it reaches our warehouse.
Skip the use of expensive gas cylinders and instead use the air compressor in combination with the xTool air dryer. Achieve burr-free cuts of 4 mm stainless steel, 4 mm aluminum, or 3 mm brass with just 6 bar of air pressure. All you need is the air compressor, the air dryer, and the xTool SaveGas™ nozzle.
Powered by a 2,200 W motor and equipped with a 20 L tank, the xTool air compressor delivers stable, continuous air pressure over 0.6 MPa for uninterrupted cutting. The manufacturer specifies a service life of 2,400 operating hours.
For thicker stainless steel, nitrogen, argon, or an air compressor with a pressure above 1.2 MPa is recommended.
For thicker carbon steel, oxygen cutting is recommended.
Note: The xTool MetalFab air compressor can only be used in combination with the air dryer.
- Size: 46 cm × 53 cm × 27 cm
- Weight: 16 kg
- Max. air pressure: 10 bar (1.0 MPa)
- Operating pressure: 6 to 7.9 bar (0.6 MPa ~ 0.79 MPa)
- Max. airflow:
- 350 L/min
- 200 L/min at 6 bar
- Tank capacity: 20 L
- Rated power: 2200 W (3.0 HP)
- Recovery time: 45 s from 0 to 10 bar (0–1.0 MPa)
- Operating voltage: 220 V
- Pipe diameter: 10 mm
- Operating temperature: -10 °C to 40 °C
- Noise level: approx. 85 dB during air build-up
- Air compressor
- Replacement filter for silencer
- Hose
- Safety instructions
- User manual
The Makeblock success story began in 2012 when Jasen Wang, the founder and CEO, had a groundbreaking idea. As a passionate maker, Jasen realised how difficult it can be to turn a creative idea into reality. This drive gave rise to his first project: Makeblock.
Makeblock specialises in promoting STEAM education. The company helps young students develop their creativity by developing educational infrastructure - including robotics modules, coding software and laser cutters. The aim is to give pupils the tools to learn technical knowledge and creative skills through play.
At the end of 2020, Makeblock expanded its portfolio and entered the field of laser machines. With the xTool project, the product range was expanded so that not only students but also adults can benefit from the solutions. Creativity is not just about developing programming robots - it is also about personalising everyday objects, such as engraving names on mugs or creating works of art from wood.
With the launch of the first product, the xTool D1 in 2021, Jasen started a new chapter in his vision. While the Makeblock success story continues, xTool marks the start of an exciting new episode.
Contact:
MAKEBLOCK (HONG KONG) COMPANY LIMITED
19H Maxgrand plaza No.3 Tai Yau Street
San Po Kong, Kowloon, Hong Kong
European subsidiary
Makeblock Europe BV
Oostergracht 48, 3763 LZ Soest, Niederlande
Phone: +31 6 1264 5740
EMail: eu@makeblock.com
Register entries:
Registered with the Dutch Chamber of Commerce (KvK): 68916752
VAT no.: NL857646655B01
